The painted sliding sash, and the patterns that depart from it
Start with the sentence the appraisal uses for the whole conservation area. The most common window type is the painted, timber framed, sliding sash. Paint, timber and the fact that the window slides are the three constants. Everything else is local, and the local part is what a careless specification throws away. Francis Radford's Holland Park houses, built between 1860 and 1879 and listed as a group, have canted bays rising to the first floor with plain timber framed sash windows. Plain, here, is the point. The bays are a counterpoint to very rich stucco. Adding bars that the opening does not have, or painting out the simplicity so the window matches a busier neighbour, fights the design.
Holland Villas Road keeps a bar the Radford houses do not. Sashes there are divided by one vertical glazing bar, except the side lights of the tripartite windows on the upper storey. That bar is part of the record of the window. Preparation does not scrape it off as an inconvenience, and a repaint does not bury it under so much film that the division disappears. The mews is different again. Wide painted timber carriage doors sit on the ground floor, stone steps rise to the former staff entrance, metal windows with pivoting openers remain beside the steps from the time they ventilated the stalls, and timber ten-over-ten paned sash windows survive on the first floor. The ten-over-ten sash is timber and is painted as a sash. The pivoting metal window is not a sash and is not prepared as timber. The carriage door is painted timber, but it is a door. Three openings, three notes.
Colour is recorded street by street, and doors are part of the note
On James Hall's Addison Road houses, nos. 62 and 64-84, built between 1855-1860, the front is fully stuccoed and the sides and rears are stock brick. Most windows on this group are painted black in contrast with the cream stucco. Black is not a universal Holland Park window colour. It is the contrast recorded against that cream. A sash on a stock-brick house further along Addison Road is not automatically given the same black because it shares the road. The sample, if the colour is being renewed, is judged on the opening, against the stucco of that villa.
Ilchester Place was built in 1928 to Leonard Martin's Neo-Baroque designs, mostly as attached pairs in pale brown brick. The framed sashes are painted white. Next to them, the front doors are six panels, raised, fielded and moulded, and most are painted black. White on the sash does not migrate onto the door. Black on the door does not migrate onto the sash. They are a pair of records, and they are the opposite of Hall's black window against cream stucco. When both are in the brief they are specified as neighbours, not as one joinery colour.
Where the appraisal does not record a joinery colour, none is invented from the next street. The Radford sashes are described as plain timber sashes, not as black and not as white. The colour already on that opening is the starting point, and a change is checked rather than borrowed from Ilchester Place or from Addison Road. Historic doors across the conservation area were slow-grown pine meant to be painted, with brass furniture. Varnished doors and stainless steel furniture are called harmful. A sash job that strips the neighbouring door back to bare pine and varnishes it has left the conservation area's joinery rule, even if the sash itself was carefully painted.
Survey each opening before paint is opened
Each opening gets its own line, because a single house can hold more than one pattern. A Radford bay can be plain while a side light elsewhere on the conservation area is not, and a mews house can put a timber sash over a metal stall window. The survey is a look and a note. It is the list from which preparation and colour are later decided.
Glass is included in that look. Cracked panes, loose putty and openings that have been boarded are written down so they are not discovered halfway through a coat. The glazing pattern is written in words the appraisal would recognise for that opening: plain, one vertical bar, or ten-over-ten, where that is what survives. A sketch or a photograph is attached to the line. The colour on the frame now is recorded separately from the colour on the cill and from the colour on the door beside it, because those three are allowed to differ.
- Which floor and which face, so a first-floor mews sash is not confused with a ground-floor carriage door.
- Timber sash, timber casement or metal pivoting window, because only the timber sash is this specification.
- Whether the sash slides, sticks, or has been fixed shut.
- The glazing pattern actually in the opening, including a single vertical bar or a ten-over-ten arrangement where that is what survives.
- The colour on the sash now, and the colour on the neighbouring door, kept as two notes.
- Any bare timber, failed paint, or glass that needs protection before coating starts.
Ease the sash and protect the glass
A sliding sash that is painted while it is jammed will be painted as a fixed light, and it will still be jammed afterwards. Easing means freeing the sash enough that it can be prepared and returned to a fit that slides. It does not mean rebuilding the window, and it does not mean altering the glazing pattern so that a plain Radford sash gains bars or a ten-over-ten mews sash loses them. If the sash cannot be moved without a repair that is outside decoration, that opening is marked and left out of the coating line until the repair is agreed.
Glass is protected before any scraping near the putty. The pane is not a surface to be rubbed back as if it were timber. Paint that has crept onto the glass is taken off the glass with the glass in mind, so the pane is not scored. Internal cills, shutters and floors below an opened sash are covered, because a first-floor opening drops debris into a room that is still lived in. External stone cills, tiled steps and iron immediately under the window are covered too. The protection is part of the job, not a courtesy added if there is time.
Prepare the timber and leave sound paint where it is
Older paint on these windows may contain lead. HSE notes that lead pigments were widely used in household paints until the 1960s. Leaded paint must not be overheated with blow lamps or gas torches. There is no burning-off of a Holland Park sash as a first step. Sound old paint is left in place. Only paint that is flaking, chipping or dusting is stripped back. The failed film is cut back to a firm edge. The sound film stays, so the moulding of the glazing bar and the edge of a meeting rail keep their shape.
Bare timber is a different condition from failed paint. Where the wood is actually bare, it is primed before the finish goes on. Where the existing paint is sound, it is cleaned and the finish is applied over it. The whole sash is not taken back to bare wood because one cill has failed. That habit makes dust, risks lead, and flattens the very bars the appraisal records. Putty that has failed is noted. Sound putty is not raked out for neatness. The aim is a sash that can take paint and still be the window it was, including the one vertical bar on Holland Villas Road and the plain frame on a Radford bay.
Finish in the recorded colour, then refit so the sash slides
The finish colour is the colour the appraisal records for that group, unless a change has been checked. On the Hall villas that is black against cream stucco. On Ilchester Place it is white on the framed sashes, with the six-panel door remaining black where that is the door in front of you. On a Radford plain sash, where no joinery colour is stated, the finish follows the existing colour on that opening unless a change has been checked against the pale cream of the walls and against whatever consent the address requires. A sample of the joinery colour is looked at on the sash, in daylight, next to the wall colour. It is not chosen only from a card.
The specification states the coating system for the timber. This page does not state a number of coats, a product name or a drying interval. When the sashes are put back, they are refitted so that they still slide. Paint on the running edges is kept from building into a wedge. A sash that looked finished and then cannot be opened has not been cared for. It has been sealed shut. The carriage doors and metal stall windows of the mews, if they are in the same visit, are finished on their own lines and are not used as a test of whether the ten-over-ten sash still moves.
Doors beside the windows stay in the painted-pine tradition. They are not stripped to be varnished because the sash work has created bare timber elsewhere. Brass furniture stays brass. The wider account of streets and colours is in the period-homes guide. Preparation of the surrounding stucco or brick is a separate decision, especially where a flank is fair-faced and must not be folded into the sash colour.
Sources for this page
The building points above are taken from the documents linked here. Preparation, protection and the order of work are general decorating practice, and they are not quotations from those documents.
Sources